This ride is over.

Generic foot. Top thread needs to go through the slit as shown. Bottom thread stays below.

This one is used on edges so they don't unravel.Sometimes seams for knits are done this way.

This allows you to go in reverse.

How long the stitch is (blue knob dictates how wide.)

Width of zigzag

The labels along the top are related to the numbers on the first wheel.

The diagram on the label shows the range of stitch that can be selected on the second wheel. For example if the first wheen is set to 1, it can go from a straight stitch to a zigzag.

These two wheels select stitches.

Half inch to the first line.

These lines are measurement lines.

Also used to adjust the teeth but don't use it. Only used for "darning".

Make certain that both threads go under the foot

Thread as shown.

It goes on the inside

It should clear the top.

When threading this arm needs to be up. Turn the machine towards the operatoor until it is up.

Asnsoon as the thread touches the white olastic piece it's done.

Use the foot oedal to engage the machine to wind the bobbin. Note not to have any thread in the needle because this machine has an issue.

Push the bobbin towards the plastic piece. It snaps into olace.

Run the thread through any hole but from the inside and then pull out about three inches

When windong a bobbin run the thread around the post and back over the thread, not under.

Foot replaced.

How to replace a shank style foot